Cool down my RSST Vapor, super intense TH.

[msmalls1982]

the ekowool is only over the cable above the tank. no ekowool is actually in the tank. My cable is a good size smaller then the rsst wick hole. this allows juice to actually come out. ekowool tends to split and fray. I made mine fray a tiny bit on the bottom so it catches juice coming out of the mesh hole. the ekowool strands acts as a sponge to pick it up. The juice flow stops when the ekowool is fully saturated and it never overflows or spills cause my fill hole is plugged.

Yea i dont even use the plug on mine and its still horrible. I am just going to have the guys at esix here in CT figure out ... the problem is. Im sick of messing with it and wasting all this time and juice and materials.

 

[msmalls1982]

the ekowool is only over the cable above the tank. no ekowool is actually in the tank. My cable is a good size smaller then the rsst wick hole. this allows juice to actually come out. ekowool tends to split and fray. I made mine fray a tiny bit on the bottom so it catches juice coming out of the mesh hole. the ekowool strands acts as a sponge to pick it up. The juice flow stops when the ekowool is fully saturated and it never overflows or spills cause my fill hole is plugged.

Did you buy a specific type of SS cable? What size (is it in MM?) Also what ekowool size? Unfortunately they don't sell either at my local store so I will need to order online. I am just so tired of this mesh crap. Sounds like the ekowool/SS cable is a lot easier. Just torch the ekowool and push the cable through it.

Does the cable wick well to bring the juice up to the area where the ekowool starts or do you have to hit your RBA horizontally so the juice touches the ekowool?

 

[msmalls1982]

Did you buy a specific type of SS cable? What size (is it in MM?) Also what ekowool size? Unfortunately they don't sell either at my local store so I will need to order online. I am just so tired of this mesh crap. Sounds like the ekowool/SS cable is a lot easier. Just torch the ekowool and push the cable through it.

Does the cable wick well to bring the juice up to the area where the ekowool starts or do you have to hit your RBA horizontally so the juice touches the ekowool?

Also do you have to torch the cable at all or do you just torch the ekowool and then put the cable through it and drop it in your tank and wrap the coil? What gauge kanthal are you using on this setup? Also how long does it last before you have to change the cable and/or ekowool? I am about to order some 2.54mm cable and 3mm ekowool from kindneypuncher.

 

[CounterCulture]

Also do you have to torch the cable at all or do you just torch the ekowool and then put the cable through it and drop it in your tank and wrap the coil? What gauge kanthal are you using on this setup? Also how long does it last before you have to change the cable and/or ekowool? I am about to order some 2.54mm cable and 3mm ekowool from kindneypuncher.

it wicks surprisingly well. i can vape vertically and it wont dry burn. ekowool stores a decent amount of juice too. 3mm ekowool and dont know exactly what size my stainless steel mesh is. what i can tell you is that it can fit inside the rsst hole without touching any of the sides. torch the cable. i used 28g hotwires (lower resistance than kanthal). ive had this setup for quite a while now. whenever i feel like it might not be hitting as good as before, i remove the rubber seal on the rsst and use a torch to burn everything off the ekowool and wire. hits like new afterwards.

here's a video of a guy who does this setup but he uses flat wire
Build: Stainless Steel Rope with Ekowool Sleeve - YouTube