Copper Pipe Mod Revised

Status
Not open for further replies.

paso

Senior Member
ECF Veteran
Jan 5, 2010
247
0
70
Rocklin Calif.
Ok I asked hoog to delete the other thread because I made a mess out of it. I will try and do better this time. This is my 5v copper pipe mod useing the 5 pin regulator that hoog sells. Thanks to Connman and BadState I was able to make it sort of. I killed 3 of them little tactile switches so I have to order more. Here is my wireing diagram useing that regulator. I did add a 470 ohm resistor in line on the led that is not shown. Now maybe Connman can make a pretty diagram for you all to see.
 

Attachments

  • pipe mod.jpg
    pipe mod.jpg
    19.5 KB · Views: 85

Connman

Super Member
ECF Veteran
Verified Member
Dec 6, 2009
903
52
62
North Florida, USA
Great job on getting the mod working paso. :thumbs:
Now it seems you are waiting on another delivery for the switch. One thing these E-cigs are doing for sure is giving the Postal service a bunch of business. We might even get a bigger Mailbox.
Hmm old mail box mod idea. :p Or maybe Id be better off doing a copper pipe mod now instead.
And I want the credit for messing that other thread up. For I did a fine job at it. :D

I`ll be making that diagram tonight and post it for sure. Thanks for your diagram to go on paso. :thumb:
 
Last edited:

Connman

Super Member
ECF Veteran
Verified Member
Dec 6, 2009
903
52
62
North Florida, USA
Ok here you go paso. Hope this is correct. :)
I tossed on a ground to atty wire incase someone didn`t want to use a copper pipe. But did note at the bottom for a copper pipe it wouldn`t be needed. Again nice job on that mod.

Maybe if someone still had the schematic (think that`s what it was called) link Hoogie posted it could help someone as well.


5Volt5PinDiagram.jpg
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread