Copper Plated Circuit Board

[Multisync98]

Attention ALL Modders!

I'm looking for a site that supplies Copper Plated Circiut Boards! IF you know of any site who carries it, please contact me. Thank you. I'm getting ready to build my own ecig. Thanks!

-Jim

 

[breakfastchef]

Radio Shack has a few different sizes. I assume you are talking about the non-perforated material.

 

[Loogie]

I'm looking for this as well. no Radio Shack in my area has it. now a question I asked in an earlier post (which was never answered)...is it necessary to use the circuit board material, or is it just needed to hold the battery connector since lens on the flashlight is flexible?

 

[shoes]

They use the circuit board to hold the connector because it is stiffer. The perferated will work, but will break easyer than the solid.

 

[nicowolf]

This should work. There is a button on the product description page to find this at a store near you. If the dinky little store near me has it, I am sure yours does too. I saw it near the soldering tools.

http://www.radioshack.com/product/index.jsp?productId=3173937

 

[Vegatron75]

I used a washer from the hardware store. The hole was in the center was perfect for the 801 atomizer. Just had to grind about 1/8 off the diameter.

 

[Nick O'Teen]

eBay is your friend: copper circuit board, Business Industrial, Computers Networking items on eBay.com

 

[breakfastchef]

You can reuse the plastic lens from the flashlight as a mount for your atomizer. It is alread the right size and is stiff enough for this purpose. I recently reinforced the lens on my 801 Magnum with a 7/8" I.D. retaining ring. Now it is super snug in the torch housing. I highly recommend using one.