Couple of probs with the Provari

[Opi21]

Hey guys, I have owned 3 provari's, 1 was lost and one was old and time for an update. The one I lost was lost just a couple of weeks ago and now I am on Provari #3. Anyways I wanted to see if anybody else has the same problem with them. My problem I mainly experience with the first one. It is when the button no longer seems to make contact half the time and you have to tap/bump the device before the button works. Almost like something is coming loose inside. The second Provari I had for about 4-5 months. And pretty much at the time I lost it I noticed it was starting to have the same problem. But horribly I lost the super expensive piece and couldn't see if it was a fluke or not. Is this a known issue or is it just my bad luck? I love the device and can't ever go back to your basic vaping but for almost 200$ (which to me seems overpriced) it should be working flawlessly for a long time.

Btw I am talking about the V2. Btw again, does anybody know when they are going to come out with V3?

 

[The Yeti]

My V1 did this as well. It's the circuit board inside the Provari coming loose (usually from dropping it).

I tried to fix it myself by putting some super glue on the tip of a long wooden skewer and putting it where the circuit board and tube meet (after re-aligning the board and button with some judicious taps on the table). Always would come loose eventually though.

Now that I know how to remove the top cap, it would be much easier to hot glue the circuit board down.

I sent mine back to Provari to get fixed under warranty.