Couple of questions about my itaste mvp

[mitsubishi12391]

What ohm is needed for this device it ranges from 3.4v-5.0? I use 50/50 juice if that matters

Anyone have this model?? what set-up do you use with good results?

I'm not new to vaping but new to vvv

 

[RoseB]

Hello I am using the iclear 16 setup on mine. It's dual coil and I believe 2.5 ohms. Cranked it up and the clearo has held up fine. No burning taste, and was using 50/50. Didn't your MVP come with a couple?

 

[djtonyb]

I use 2.2 and 2.5 ohm coils in my Protank... 3.8 volts on the 2.2 and 4.0 volts on the 2.5s seems to be the best spot for my all-day vaping needs. You can use just about any resistance on it, but I don't like the taste of anything below 2 ohms, even with the voltage turned down accordingly.

 

[zacbandit]

I use kanger protank with 1.8 ohm coil works best at 3.7 I think but good all the way to 4.0

 

[afullmargin]

I also use 50/50 and get great results from a 2.4 ohm on my vivi nova - the 1.8 ohm isn't *bad* but not as good as I like and I've never bothered to go higher.

 

[DavidOck]

I like to keep my coils in the 2.4 range, as it allows for greater variation on the MVP (or any VV/VW device). Greater variation means more ability to fine tune the vape.

That said, best procedure is to just start low and increase the voltage until flavor starts to go south on you, then back it down slightly.

We all have different tastes, different juices. There is no one "right" setting. What I like for my juices may be over-whelming or wimpy for you and your juices.