My smok Cube 2 has started displaying "ohm too high" no matter what I have tried to connect. I have been in contact with the manufacturer and thier warranty people here in USA. Both tell me to contact other. Any suggestions or help will be greatly appreciated. Thank you in advance, Frank R.
Cube 2 malfunction
- Thread starter frank3577
- Start date
- th_trl_thread_readers 0
- Status
Silly question, but have you tried cleaning out the 510 connector with a Q-Tip dipped in rubbing alcohol? If that connection is wet or really dirty it will result in a poor electrical connection which could cause the error.
Sorry. I just replied to you in e-mail instead of here. I have been building box mods, regulated and unregulated and doing repairs for friends. I disassembled this one this morning and checked for hot spots on the circuit board. Did a firmware upgrade but no luck. Thank you Again for the quick reply.
- Status