Sorry, wrong forum, but I'm still flagged as new because all I do is troll (and donate $$$).
I have been replacing cracked clearomizer tubes with trimmed BD 3 ml syringes. I vape mainly Atomic Cinnacide, so cracking is inevitable and frequent. My problem is that when I cut the syringes to size, the ends are quite ragged. I use a Dremel rotary tool with a thin cutting disk. Also, the ends where it is cut it tend to bend in a bit, requiring a lot of filing for it to fit over the silicone ring. Any suggestions on alternative means of cutting them, or how to make them smooth and flat? Or am I doing something wrong?
Thanks so much for any assistance.
Lou
I have been replacing cracked clearomizer tubes with trimmed BD 3 ml syringes. I vape mainly Atomic Cinnacide, so cracking is inevitable and frequent. My problem is that when I cut the syringes to size, the ends are quite ragged. I use a Dremel rotary tool with a thin cutting disk. Also, the ends where it is cut it tend to bend in a bit, requiring a lot of filing for it to fit over the silicone ring. Any suggestions on alternative means of cutting them, or how to make them smooth and flat? Or am I doing something wrong?
Thanks so much for any assistance.
Lou
