Cutting E-Liquid w/water?

Status
Not open for further replies.

UntamedRose

PV Master
ECF Veteran
Verified Member
Mar 23, 2010
7,427
39,112
Homeish now
If they are adding water(and a few do, but not like your talking), it's not going to be a whole lot like less then 10% water...and most only do if they are using a lot of VG as it's a lot thicker then PG.

Water has a lower viscosity the PG/VG...so to much would make it just run out of the atty(horrible leaking, a little is kinda normal).
Water also needs a higher temperature to evaporate, so to much would make it not vaporizers correctly. (I'd guess it act like a flooded atty, until it ran out the bottom)

I dont think this something we need to worry about.
It's not the VG and PG that costs a whole lot in eliquid.
By expense to make one bottle cost per ml for liquids... the Nic is the most expensive part, the flavoring, then the bottle, VG, and lastly PG.

If a supplier was wanting to cut corners, it be by lowering nic levels without labeling it as such.
Like selling 24mg...but it's really 15mg
 
Last edited:

Shad0w

Super Member
ECF Veteran
Jun 12, 2010
595
63
Trapped by Schrödinger's cat....
Shaka Kaka!

Your momsanus is the best! little loose but enjoyable. Recommended vendors by members? you mean by you? You are the expert on watery liquid. All vendors you recommend arent 100% legit and have fun paying for overpriced e liquid.
"Shakas words smell like KAKA"


Someone has apparently been reading "How to Win friends and Influence People".... :p
 
Status
Not open for further replies.

Users who are viewing this thread