Well I knew this would happen sooner or later because I have dropped all my mods at one time or another.I was walking out into my garage and my wifes kitten ran between my legs causing me to loose my balance so I wouldn't crush her.The BP shot out of my hand and hit the concrete atty first at an angle.I was so ...... off I can't even describe it,I love this thing.I picked it up to check it out and not a mark on the body but my 801 was a bit bent to the side.The red light was on so I tried it and nothing.Removed the cap and found the wire broke off the cap connection.I soldered it back on and shrink tubed it and now it works fine again.The only other thing I noticed is the electronics inside seen to have shifted slightly towards the front.The wheel used to turn freely but now there's a bit of resistance,which I like because it stays put if my finger bumps it.Overall the BP held up better than I thought it would.