- Status
are you using a low resistance dual coil carto? Your PV may not be able to cope with the current draw. Or, the carto is too low of a resistance, making your pv think its shorting out, thus, protecting itself. Hope this helps
sorry to steal this thread... i also have broght a dct recently... i did not punch another hole la... but when i start to vape that time the juice will spill out from the drip... and i can taste the the hot juice spill into my mouth...
either that or you over filled your carto when priming for the 1st time
When you first fill your dct, as you replace the top cover, liquid will be forced into the dct carto due to air pressure, make sure you try blow out the excess first before vaping.
Like what dirtdevil said, don't over prime as liquid will still go in when u replace the cover
Last edited:
Nv had gd experience with dual coils cartos on DCT..Totally gave up on them..
1) Tried before filling up the tank, close down the gap and invert the DCT so that when carto is fully inserted, juice wont be force in by pressure(leaks 1/2 a tank later)
2) Did the recommended method, nv prime cartos from the top end.(leaks 1/2 a tank later)
End up using Boge XXL LR cartos now, totally no issue at all..
Interesting, never had that problem before, check you seals. If there isnt vaccum in the tank, it will leak. Either that or you liquid's too thin..
will try... blow the juice out from the bottom hor... the one that connect to the battery.
hey city1405 how many ohms are you using?
apparently the ovale v6 has some issues with LR cartos. try using the higher ohm cartos for a few vapes then lowering the voltage to 3.7 and changing your carto. i saw 2 youtubers who had the same problem as you.
i wanted to get the ovale v6 so i did some homework on this
apparently the ovale v6 has some issues with LR cartos. try using the higher ohm cartos for a few vapes then lowering the voltage to 3.7 and changing your carto. i saw 2 youtubers who had the same problem as you.
i wanted to get the ovale v6 so i did some homework on this
Seal all working okay(As tested with a Boge XXL)
Juice wise, my fren tested using VG based liquid, same results..Initially the pre punch lobang was abit too small so he enlarge it slightly and his liquid did manage to go thru but leaks after using it for awhile.
- Status
