Well it was fun while it lasted.
After just a couple weeks my rDNA40 has decided to call it quits.
At about lunch time today today I noticed I was getting the "Check Atomizer" message when attempting to fire.
I checked the usual culprits, made sure my atty (Magma built w/ nickel) was snug and then made sure the terminals were snug as well.
No luck though. I removed the atty and the battery, then reconnected everything and still got the check message. Awesome..
Got home and tossed on a couple different attys and got the same message. I tried one last time with my Magma (after re-setting the mod by removing the battery again) and PRESTO! It is working again, EXCEPT now it wont recognize that I am using a nickel coil!
So I swap out to a different atty with a nickel build and now it is working as intended.
However, 1 hour later and I am back to the check message no matter what.
This is one of the newer revisions with all the bells and whistles; bigger screen, faster charger, annoying "you put the battery in backwards, dummy" buzzer etc etc.
Needless to say I am pretty disappointed. My first gen cloupor DNA30 Hana clone lasted longer than this! At least that hunk of junk went a little over a month before I needed a warranty replacement.
I will call VaporShark in the morning and go through the motions.
In the mean time, back to my good ol IPV2, which has been through hell and back over the past 7 months. Dropped several times, rained on, and accidentally soaked in e-juice more times than I care to admit, but never so much as a hiccup.
Starting to feel like I should have bought a SX-Mini instead..
After just a couple weeks my rDNA40 has decided to call it quits.
At about lunch time today today I noticed I was getting the "Check Atomizer" message when attempting to fire.
I checked the usual culprits, made sure my atty (Magma built w/ nickel) was snug and then made sure the terminals were snug as well.
No luck though. I removed the atty and the battery, then reconnected everything and still got the check message. Awesome..
Got home and tossed on a couple different attys and got the same message. I tried one last time with my Magma (after re-setting the mod by removing the battery again) and PRESTO! It is working again, EXCEPT now it wont recognize that I am using a nickel coil!
So I swap out to a different atty with a nickel build and now it is working as intended.
However, 1 hour later and I am back to the check message no matter what.
This is one of the newer revisions with all the bells and whistles; bigger screen, faster charger, annoying "you put the battery in backwards, dummy" buzzer etc etc.
Needless to say I am pretty disappointed. My first gen cloupor DNA30 Hana clone lasted longer than this! At least that hunk of junk went a little over a month before I needed a warranty replacement.
I will call VaporShark in the morning and go through the motions.
In the mean time, back to my good ol IPV2, which has been through hell and back over the past 7 months. Dropped several times, rained on, and accidentally soaked in e-juice more times than I care to admit, but never so much as a hiccup.
Starting to feel like I should have bought a SX-Mini instead..
