Decided on the Prodigy V3

[RockAction!]

After a month of researching, debating, wavering back and forth, and asking a multitude of questions, I finally decided on going with the V3. I am new to vaping and currently use an ego-t. Great for my job (in construction). Easy to fill, carry, and if I lose it or damage it, no worries, it's relatively inexpensive as a unit. That being said, I want something for home and personal time use at a higher quality. As said before the V3 is what I am going to go with. The last (maybe) and only (probably) question I have is whether to go with the 3.7v or the 6v. Like I said, pretty new to all of this and just can't make a decision. I know I can do both with the unit, but just wondering where I should start.

 

[RedAlert]

Being that you're pretty "green behind the ears", I'd start with the 3.7v. It will pack a little more punch than your ego, and you can try out LR atties at lower ratings since the 17670 can support them better and you dont have to worry about killing a mosfet switch. Once you get used to using a LR(1.5 ohm) atty at 3.7v, you can step it up to the 6v, but I'd suggest using a higher ohm atty(3.5 ohm and up) You will most likely kill a few practicing your technique, so dont be discouraged.

From what I have experienced in high voltage usage: coffee and tobacco flavors usually do pretty well at 5v+, but most other flavors either burn up or lose flavor at those voltages.