RDA Derringer Replacement Screws

[SpectralWolf]

Hello and don't fail me now. I ordered a Derringer V3 rda and absolutely love it until I was putting in a fresh build and stripped a screw and BTW the place I ordered it from didn't give me any replacement screws. Thus I couldn't use the rda I emailed them and told them they didn't supply any so they're sending me some for free.

On to the question does anyone know what type of screw they use specifically, where I can buy them, and if there is an alternative screw like a Philips head etc? I uploaded a pic of the screw. I know someone else has had to have done this. Thanks.

 

[LobsterGoD]

Ace hardware usually carries a handfull of m2 alen head machine screws, I've found some there that work in my mutation x v2 and also found a set that worked for my N23. Might be worth the time to check if they have something that would fit your derringer.

 

[inswva]

Derringer grubs are 4-40 x 1/8".

 

[SpectralWolf]

Ace hardware usually carries a handfull of m2 alen head machine screws, I've found some there that work in my mutation x v2 and also found a set that worked for my N23. Might be worth the time to check if they have something that would fit your derringer.

Thanks for the info, I will deffidently look into it.

 

[SpectralWolf]

Derringer grubs are 4-40 x 1/8".

Perfect. Do you know where you can order some of these from?

 

[inswva]

Perfect. Do you know where you can order some of these from?

Set screws, Allen, Cup point, Stainless steel 18-8, #4-40 - Bolt Depot

 

[SpectralWolf]

Set screws, Allen, Cup point, Stainless steel 18-8, #4-40 - Bolt Depot

I ordered these, thanks a lot.