Difficulty getting cartomizer to take bobas

[Ray J Neal]

I'm hoping tha someone has a bit of good advice for me here. I've been vaping cartomizers (2.8-3.5 ohm) on my provari exclusively. Mostly clearer and thinner liquids, mostly from bwb. No trouble at all drip filling my cartos, I have gotten 42 drops in one with a taryn spin here and there while filling.
So today I received two bottles of bobas bounty. I was order #6000 and got a free bottle with a nice little note, "winner winner free chicken dinner". Thanks a lot you two. ANYWAY, I noticed immediately how difficult this thick, dark juice was for the filler to absorb in the cartos. I only got four drops in and had to do a taryn spin. Quite time consuming to keep doing the spin. But my God, this juice is awesome. What the hell are the flavor combinations in it?!

So, anyone got a bit of advise?

 

[Juicehead]

Ive been filling V4L coolcarts with bobas without any problems. I'll usually do 8 drops then let it sit for a minute or two. When I come back, the liquid has been absorbed. Then 8 more, let it sit. Then a few more drops and taryn spin the the final drops down.

Did you start with a brand new empty carto?

 

[Ray J Neal]

I sure did. A separate carto for each flavor, then a label gets tossed on

 

[Stownz]

Its not the flavor, its mixed with 100% VG. Most all of AVs stuff is pure VG, very hard on cartomizers, killers for CE2R4s.

Can dilute it down with some PGA, Everclear is my choice.

 

[Ray J Neal]

No dilution, just patience. It takes a bit longer to get the carto filled how I want, but once I do, its good to go. I'll just keep an extra filled in my toolbox hutch at work and have it ready if I need it. Although, I still prefer my ego for work. Id hate to have the provari fall. Although, the only time I could see that happening is if someone were to get on their knees to rack a car, but no one does that! Not when your on the same car line day in and day out, anyway. I still sometimes kneel when racking a car at home, but that's another story.

 

[jed]

Ray J Neal
So, anyone got a bit of advise?

from ave's Common Questions, Issues, Concerns

VG Juice Is Too Thick For My Cartomizer/Drip Tip. What Can I Do?

A.) VG liquids tend to be extra viscous. If you are looking to thin out a liquid the best option is a few drops of distilled water. Other liquids may be used to thin out a liquid but none will retain the flavor and strength of a juice like a few drops per bottle of distilled water. You can also use: PG (propylene Glycol) and/or PGA (pure grain alcohol)

 

[SuZamme]

I take a syringe with a plastic luer loc tip and fill from the batt end until liquid appears at the mouth end. Put on the condoms slowly (starting with the one at the batt end) and then fill another one. I always have plenty ready-to-go.

 

[Ray J Neal]

I just got a 5ml syringe with luer lock tip today (tip came with the ce2 clearos). I really like that idea. On a side note, let me tell ya, I REALLY do not like the clearomizers. Nice concept, but total garbage, IMO. Burnt taste. Seems the wicking can not even keep up with 4v on my VV. HORRIBLE taste. I had to suck out as much juice as I could with the syringe. Too bad these don't work like I had hoped. Will the MAP tanks be better?