direct dripping bridgless atomizer for innokin vv v3

[xxxtn12]

Hello everyone!

I have seen people with mech mods direct dripping. I tried it and the flavour just puts a smile on my face everytime i vaped it.
There was just such a difference in flavour.
I have an innokin VV v3, would i get the same results if I used a dripping atomizer, is there even a dripping atomizer for it?

Or is it because it was a mechanical mod?


Thanks,
Newbie Christian

 

[Dakota Jim]

you can drip into any appropriate atomizer (ie: a bridgeless atty like mentioned above) you do need to be careful not to over drip though - 3-4 drops max otherwise it will flood the coil and leak down into your battery connections. Yes it will work with your vv3. I have used a 510 bridgeless 1.9 ohm atty on a regular ego battery and it worked fine.

once you get more knowledgeable you can actually get a nice inexpensive RDA in the $7-15 range that will allow up to 12 drops in it due to a small well it wicks out of (ie: igo-L) which will work fine on your vv3 as long as you keep the ohms above 1.3

and welcome to the ecf

 

[CreepyLady]

Yes - you can absolutely use a bridgeless atomizer for dripping on your VV v3

 

[NicoHolic]

Dripping a bridge-free atomizer is, IMO, the ultimate in vaping, especially for flavor. Many agree. http://www.e-cigarette-forum.com/forum/atomizers-cartridges/405910-regular-atty-drippers-dying-breed.html

You can use any 510 (510 drip tip required) or 306 (306 drip tip required) above about 1.2Ω on your VV. Here are a couple I've had good experience with:

Empiremods Bridge Free LR510 1.5ohm

Empiremods Bridge Free LR510 1.8ohm

 

[xxxtn12]

Thanks for the welcome Dakota Jim!
Where did you get your 510 bridgeless 1.9 ohm atty?

 

[xxxtn12]

wow thanks for the link Nicoholic, i will check it out!