I like my hcigar stingray clone and the patina I put on it. Some Noalox made the threads a little smoother. Now I am trying to make the fire button better. If it is pushed a little off center it will hang up so I am trying to take it apart to see if there is anything I can do. I unscrewed the magnet and I can not see any way to get the two metal pieces apart. Does anyone know how to do this?
Disassemble stingray clone fire button
- Thread starter p7willm
- Start date
- th_trl_thread_readers 0
- Status
I don't know if you ever fixed your problem, but do not remove that pin. it's not the problem. If you remove it the button will be very wobbly. I used teflon tape to provide a more snug fit between the pin and the thing i'm not sure what to call. Use a bit of your preffered grease to lube the pin so it moves more effeciently. Next, I sanded the center post that the bottom magnet screws into ever so slightly. I also sanded the outer and inner portion of the piece that fits down into the button. Finally, when you replace the threaded delrin piece be sure to tighten it as much as you can. My button is amazing now. YMMV.
- Status
Similar threads
