DIY ejuice questions/advice, and best flavours to use.

Status
Not open for further replies.

rsvmad1

Full Member
May 7, 2015
6
0
43
Hi.. im pretty new to vaping.

Day 4 of no smoking, doing well with my Kik Premium pen.

Its time to upgrade ;). I have ordered the Kangertech Kbox 40w mod and will soon be ordering the Aspire Atlantis 2.

As for ejuice, im already using a lot to say im only using a cheap vapor pen, so with me upgrading to a 40w mod with sub ohm tank it makes sense to think im going to be using a lot more so it also makes sense to make my own juice and save a bit of cash.

Ok, so im thinking 80/20 pg/vg mix.. I have done some research and tried using the online calculators but I would rather ask to be on the safe side.

Im ordering:
500ml VG
100ml PG
100ml (72mg nicotine VG based)
Flavours (PG based)

Could someone please tell me how much of each I will need to make 30ml @ 12mg nicotine? and the same 30ml but with 6mg nicotine??

Really appreciate any help/advice

what companies are are you using and what are the best flavours? (your personal opinion)

Thanks in advance.
 

Completely Average

Vaping Master
ECF Veteran
Jan 21, 2014
3,997
5,156
Suburbs of Dallas
You always need to add in your flavorings when calculating to reach a specific nic level. People often forget that the flavorings dilute your mixture.

As for how much flavoring to use, that depends on where you get them, what flavors you're using, and how strong you want them to be. Different vendors sell different strength flavorings, so you may need 15% flavoring from one vendor and only 5% of the same flavor from another vendor to reach the same level.

There is an entire DIY section here:

DIY E-Liquid | E-Cigarette Forum

I highly recommend you spend some time reading through it. It can be overwhelming at first with the vast amount of information, but there's a lot of good threads about specific flavoring vendors and the recommended amounts for their specific flavors. There's also a Recipe section which will give you a good start on how to produce your own mixtures.
 
Just used a calculator and to make 12mg 80%PG / 20%VG you'll need
5ml of your nic and 24mg PG and 1 mg VG - but that's not including flavourings.
For 6mg....
2.5ml of your nic and 24mg PG and 3.5 mg VG

Adding flavourings will change the ratios a little depending on how much you want to use.

Done with Ejuicemeup calculator.
What would be a fair donation for your Ejuice calculator download?
 
Status
Not open for further replies.

Users who are viewing this thread