DNA 30 reading high ohms.

[jking17]

I searched all around but couldn't find an answer. I put a genuine dna 30 in a cloupor box, new 20 guage wires, switches, varitube adjustable 510, Samsung 18650, authentic dna and charger.

The 510 I drilled and tapped into the box, grounded the negative coming from the board to the case, on raw metal.

I make micro coils using 28 guage, rayon wick.

Issue: ex, coil tested on ohm meter= 1.21. Tested on mvp2 = 1.2. Put on DNA and fired and the ohms are reading 1.4 ... it is .2 ohms higher on every coil i build. Did I wire something wrong? Could something be loose? Is this even a problem?

Troubleshooting ideas?

Thanks everybody.

 

[rhelton]

My sx350 reads .20 lower than my meter does. I trust my sx more than my meter and really .20 is not allot, your not going to notice any difference in your vape. I use varitube 510's I have three of em and they are great.