DNA 30 saying check atomizer

[jcutler123]

My dna 30 which I received a few days ago was working fine with one of my Kayfun tanks and then the next day it says check atomizer. The same Kayfun works fine on my MVP and all my other tanks work on the DNA 30. I have a nautilus mini and a different Kayfun that both work fine on the DNA 30. Its just the one Kayfun that says check atomizer yet it works fine on the MVP. What could be causing this?

 

[gpjoe]

Pretty sure that means that the 510 pin on your atomizer is not making contact with the 510 connector on the mod. You have to make sure it's tight to the mod. If it still won't fire you may need to adjust the 510 on your atomizer, if possible. I had the same problem with my Eleaf Lemo. Fortunately it has an adjustable 510, so I backed out the pin and it works fine now.

 

[Heespharm]

Also when the ohm is too low it'll say that


Sent from my iPhone using Tapatalk

 

[classwife]

Moved to Variable Voltage APV Discussion from APV Discussion

 

[zoiDman]

My DNA 30 which I received a few days ago was working fine with one of my Kayfun tanks and then the next day it says check atomizer. The same Kayfun works fine on my MVP and all my other tanks work on the DNA 30. I have a nautilus mini and a different Kayfun that both work fine on the DNA 30. Its just the one Kayfun that says check atomizer yet it works fine on the MVP. What could be causing this?

Sounds like the Center Pin on your DNA30 has gotten Pushed Down and is Not Making Contact. Or your Build is Too Low.

What are the Ohms of your Build?

And is the Center Pin on your DNA30 Adjustable?

 

[jcutler123]

1.2 ohms. I adjusted the pin on the tank and it worked and then took it off and put it on later and it didn't work again

 

[zoiDman]

1.2 ohms. I adjusted the pin on the tank and it worked and then took it off and put it on later and it didn't work again

1.2 Ohms isn't to bad.

Sometimes when a Mod is New, the Center Pin on the Mod will work it's way Down until it is Fully Seated.

 

[jcutler123]

Its just strange because the other kayfun works fine and I didn't have the move the pin down on it

 

[zoiDman]

Its just strange because the other kayfun works fine and I didn't have the move the pin down on it

Maybe it is Something else? It's hard to know what is going on Sometimes.

But the Center Pin on a New MOD has been know to Move. And when it does, it Always goes Down.

 

[Nomoreash]

Check the build on your Kayfun. Make sure the wire is secure, screws are snug and the coil isn't shorting against the center tube. If that checks out it's most likely your center pin isn't making contact with the connector when screwed in.

You may have to adjust the Kayfun each time, I've got one like that, the adjustment screw spins easy so when I screw it in the mod it spins. If I remove it I have to re-adjust it to where it makes contact again.