Dna 75 therion

Status
Not open for further replies.

APathos

Senior Member
ECF Veteran
Jul 16, 2016
114
259
CA USA
github.com
Yes, you can look at the spec - https://downloads.evolvapor.com/dna75.pdf

It works fine in TC (because of how TC works), but in wattage mode, it would be the same for any 75watt device. Just look at a chart like: http://ohmvape.e-monsite.com/medias/images/tableaux-des-puissances.jpg to see what you need if you sub ohm in wattage mode. Ill sub ohm in tc (~0.15) and ~1.0 ohm in wattage mode.

Addition: Along with P=V^2/R, you should also consider amps your device/battery is capable of i.e.: I=V/R
 
Last edited:

Spirometry

Super Member
ECF Veteran
Verified Member
Oct 13, 2014
338
469
New Orleans
Yes, you can look at the spec - https://downloads.evolvapor.com/dna75.pdf

It works fine in TC (because of how TC works), but in wattage mode, it would be the same for any 75watt device. Just look at a chart like: http://ohmvape.e-monsite.com/medias/images/tableaux-des-puissances.jpg to see what you need if you sub ohm in wattage mode. Ill sub ohm in tc (~0.15) and ~1.0 ohm in wattage mode.

Addition: Along with P=V^2/R, you should also consider amps your device/battery is capable of i.e.: I=V/R
The voltage and amp limits are the same if in wattage mode or TC mode. As far a regulating power, there is no differance between the two modes.

However in TC mode, you have to realize the resistance of the wire will change. So when building higher resistance coils, you have to take into account of what the resistance will be at your vaping temperature.
 
Status
Not open for further replies.

Users who are viewing this thread