I have several DNA mods and love them.
Last night, I coiled and wicked a pair of tanks and screwed one on.
Got the new coil message and chose new, it had the correct resistance value.
Took a couple of hits, and yuck! I noticed the Ohms too high warning flashing.
Put the other tank on, and it wouldn't create vapor at all.
Ok, rechoose the right profile. Same. I put it on the device monitor and didn't see much.
So, because of the Super Bowl, I just set it on power mode and vaped.
This morning, I got the DNA TFR CSV file from Steam-Engine again and uploaded it to the mod.
Presto! Vapes as expected again.
My tip? If a tank that had worked before doesn't vape well and nothing seems to be amiss, get a fresh CSV for the metal used and load it.
This has happened twice on different mods with different tanks. Both times the new CSV fixed my problem.
Last night, I coiled and wicked a pair of tanks and screwed one on.
Got the new coil message and chose new, it had the correct resistance value.
Took a couple of hits, and yuck! I noticed the Ohms too high warning flashing.
Put the other tank on, and it wouldn't create vapor at all.
Ok, rechoose the right profile. Same. I put it on the device monitor and didn't see much.
So, because of the Super Bowl, I just set it on power mode and vaped.
This morning, I got the DNA TFR CSV file from Steam-Engine again and uploaded it to the mod.
Presto! Vapes as expected again.
My tip? If a tank that had worked before doesn't vape well and nothing seems to be amiss, get a fresh CSV for the metal used and load it.
This has happened twice on different mods with different tanks. Both times the new CSV fixed my problem.
