DNA40 Reading Ohms WAY too high... halp?

[murdurturtle]

I built a dna40 squonker and the mod is now reading a .4ohm coil at 4.5 ohms. Is there anything that would cause this?

http://i.imgur.com/sEnsGqS.jpg

here is a picture of the internals... the positive to atty has since been relocated to the proper longer positive pin.

http://i.imgur.com/DO5ahLl.jpg

 

[tehdarkaura]

I built a dna40 squonker and the mod is now reading a .4ohm coil at 4.5 ohms. Is there anything that would cause this?

http://i.imgur.com/sEnsGqS.jpg

here is a picture of the internals... the positive to atty has since been relocated to the proper longer positive pin.

http://i.imgur.com/DO5ahLl.jpg

get your dmm and measure resistance from the solder point on the board to the 510 -- my guess would be tube your using for the 510+ but you'll have to check to be sure.

 

[Phassat]

Is it expensive to DIY that?

 

[ozen]

Is it expensive to DIY that?

Nope, less than $100 including the dna board.

 

[Phassat]

Unfortunately I don't have the skill... Can't justify to buy a vaporshark or flask with dna 40

 

[rhelton]

Unfortunately I don't have the skill... Can't justify to buy a vaporshark or flask with dna 40

The new SXMini will be out this week with TC. If you check out Varitubes SX350 thread here it has all the details. The mod is beautiful and they function flawlessly.

 

[murdurturtle]

Nope, less than $100 including the DNA board.

Not really.. I have invested a significant amount in tools to make them nice though. So far I have $2500 into a cnc mill plus a hakko fx888d soldering station.

Here is my current portfolio.

murdurturtle's mod portfolio - Album on Imgur

 

[ozen]

Not really.. I have invested a significant amount in tools to make them nice though. So far I have $2500 into a cnc mill plus a hakko fx888d soldering station.

Here is my current portfolio.

murdurturtle's mod portfolio - Album on Imgur

Awesome portfolio you got there . I mean by less than $100 for the mod itself minus the tools needed to built one.