Does your Cyclone and/or ERA atty's...

[marsos52]

LEAK, and get juice all over the mod?

I had to try the Cyclone and the ERA atty's to compare against the RM2. Both the ERA and the Cyclone are great for making thick clouds and giving really good flavor. But, I find them both to leak, originally I thought it was leaking from the 510 connection. Now I am quite sure they leak thru the air hole. Both atty's get extremely wet with juice inside the walls of the atty cover. I think when this happens the juice finds its way out through the air hole. If I remove the cover they are flooded with juice.


The RM2 never has this issue. the RM2 is a airier vape then the ERA and Cyclone, but all so close. I have the same size air hole in all three units. slight difference in the hit. the RM2 cloud density is not quite as thick as the others, but again all so close.


build wise, the RM2 is I little easier because the platform base is a tad wider.


All in All, I like them All, (haha)

So I'm wondering if any others find the same glitch with juice build up?

 

[Filthy-Beast]

I drilled a lower drain hole in the center pin of my BF Cyclone so it drains better. I've also got the AFC top with both holes wide open so it is something I'm worried about. so far I've only been using it around the house so not a problem.

 

[wongster360]

So I'm wondering if any others find the same glitch with juice build up?

If it's leaking out the air hole you're just squonking a little too much and flooding the chamber


Sent from my iPhone using Tapatalk 2

 

[Justice]

Yep if it leaks your flooding it. The rm2 has a bottom juice hole so much of the excess will flow back down. The ERA doesn't do this.

 

[HzG8rGrl]

Take note of how you hold your Reo when vaping. Then thread the atomizer base onto your Reo and take note of where the coil will need to be built in order for the coil and air hole to be facing up when you take a vape.
This won't help if you flood a large amount, but it does help if you tend to flood just a bit.

 

[marsos52]

squonking to much ......hmm ok I try less squonking..

 

[unloaded]

Put a small oring around the 510 connection before you screw the atty to the mod. This will allow you to align the coil/airhole where you want and prevent leaking from the connection. I use the spare that comes with the RM2, its about the perfect size.