How long of a draw do you normally take? Maybe I need to up the nicotine level or something because I normally hit the 10 second cutoff time using my ego battery w/ kanger pro tank
Draw time?
- Thread starter MISTERDIEABETIC
- Start date
- th_trl_thread_readers 0
- Status
The amount I inhale is entirely dependent on the situation. I vape at work sometimes so I have to take shorter puffs to keep the vapor from flowing over into my neighbors cubicle. When I am out and about.... let me check....looks like 3-5 seconds. and thats with an ego and a protank as well (good set up). Nicotine does take time to set in, its nothing instantaneous and vaping in general gives less nicotine than a normal cigarette, so it takes a little longer to feel the effects. Hang with it though, and if you need to you can get higher nic concentrations, i generally use about 18mg and after a while, it became enough to do the job.
Happy vaping
Happy vaping
Usually, for me, it depends on my setup - if I'm at a higher voltage, I don't need to draw as long (and vice-versa for lower voltages).
But if you're hitting the cut-off time and not being satisfied by vapour production, I'd check your tank/clearomiser/&c to make sure everything's in order.
But if you're hitting the cut-off time and not being satisfied by vapour production, I'd check your tank/clearomiser/&c to make sure everything's in order.
Have you actually timed it? I noticed some ego batteries have more like a 6 sec cutoff.
You may want to either swap out the coil on the PT for something less than 2.0 ohms, or look into a variable voltage battery like a Twist or Spinner. Maybe both?
If you push 4.0v across a 1.8o coil, you're getting 9w of energy, which should vaporize any juice out there. That's just about the limit you'd want to push battery and coil in an eGo setup.
If you are using a regular ego battery then yeah it takes that long to really taste anything but if you got a Twist or a Spinner you could turn it up a little and it would hit harder.
I was having that trouble with ego also, but switch to the kanger t3 tank and it solved that problem
I hit the cut-off time on my Vision Spinners a lot. With my SLB ego-v mega V2's and my Vamo, I don't seem to as much. I was reading somewhere that at least one make of mod, and perhaps more, have a 16 sec cut-off. That Would be nice. JD
I was looking to get either an evic or vamo v3. I just put a new atomizer in the pro tank 2 days ago and cleaned the tank out.
JDI started with an ego style and went to a vamo 2. Big difference and enjoy the Vamo vapor production and the ability to adjust as needed.
- Status
Similar threads
- Locked
