drip mode ody

[Batsu]

just paid for my drip mode ody, can someone direct me to some videos on how to use this thing, have wanted a rebuildable atty forever, and they came in stock at COV... so throw me a bone please =(

 

[Huffelpuff]

http://www.e-cigarette-forum.com/forum/gg/238074-odysseus-official.html

1st page there is a video for the drip mode. Good Luck w/ your Ody!

 

[Batsu]

i found it, lol, just curious, later on is there a way for me to upgrade to the tank setup if i wanted too

 

[Huffelpuff]

Golden Greek - E-Cigarette Wiki

You can look at the diagram for the Ody and get a feel for the parts you will need to upgrade.

 

[bushmasterar15]

Guess if you snooze you lose. Didn't get a notification they were in stock.

 

[Batsu]

Guess if you snooze you lose. Didn't get a notification they were in stock.

bossplayervinny posted on facebook that they were in stock, i wasn't even looking for one

 

[Huffelpuff]

Bruce posted on the GG Talk thread.. is where I found it.

 

[Serpent67]

Still in stock.

Odysseus parts section, first page, first item.

Go get em

 

[fright88]

i found it, lol, just curious, later on is there a way for me to upgrade to the tank setup if i wanted too

Yes you can upgrade to short mode tank with the following pieces when they are in stock.
Odysseus Base
Odysseus Cap
Odysseus Mouthpiece Cone - Short Mode
Odysseus Tank - Short Mode
Odysseus Small Cap Mouthpiece Nut

or you can go big mode tank with the following
Odysseus Base
Odysseus Cap
Odysseus Small Cap Mouthpiece Nut
Odysseus Tank - Short Mode
Odysseus Tank Extension - Full Mode
Odysseus Tank Extension Clear - Full Mode

you would also need a mouthpiece which COV doesn't have a part for but this one may work (I have seen one person use it with Ody big mode)
Odysseus Mouthpiece Cone - 510 Full Mode

 

[trovatur]

Got my oddy drip mode and get a coil done at 1.9 ohms but it is very airy on my stealth and flavor is lost. Any way to improve this?


Sent from my iPhone using Tapatalk

 

[Hrathor]

Got my oddy drip mode and get a coil done at 1.9 ohms but it is very airy on my stealth and flavor is lost. Any way to improve this?
(1) Adjust the center pin to to the stealth (2) if that doesn't take care of it enough, put an o ring over the holes in the connector (3) Get the stealth base when it becomes available
Sent from my iPhone using Tapatalk

Basically you don't want the center pin sticking out too far past the bottom of the male 510 connector. If that still doesn't work an oring over the holes will help. Different thickness rings can make for different airflow, so experiment until you find one that works for you.
Imeo's is making the base that fits flush and has cuts in the bottom to allow some airflow. Hopefully they will be to the vendors soon.

 

[trovatur]

Thanks a lot. I got some improvement now. and I score some parts other than the top cap and o rings to convert it to short mode. Is the oddy top cap the same as the ufs top cap?


Sent from my iPhone using Tapatalk

 

[martinc]

Nah,its smaller