Dripper for Mini 2.1

[Rev. Stabard]

Hi All,

Normally I use my RM2 on my mini 2.1. Works like a champ and not looking to replace it for everyday use. However, I would like a nice little dripper atty for testing DIY juice. I use single coils and don't sub-ohm, though I would like the ability to build a dual coil and possibly sub-ohm in the future.

All that being said, any suggestions for one that will fit on the mini, be easy to build on and be flexible in terms of how I want to build it?

Thanks much!

 

[scemmer]

You can get a top fed Igo-s that will fit. Or just stick an empty bottle in your Reo and drip in your rm2.

 

[Filthy-Beast]

Any standard atomizer will work on it. It's been a while but I used to use Cisco Spec and Ikenvape atomizers.

 

[Rev. Stabard]

Thanks all, I wasn't sure if I needed something special. Worse case scenario I've got a 510/510 adapter laying around...

 

[Rev. Stabard]

You can get a top fed Igo-s that will fit. Or just stick an empty bottle in your Reo and drip in your rm2.

I ordered an Igo-s yesterday. Will see how that works out. I like the empty bottle idea but I also like the ability to use my neme for testing if I so desire. The Igo will give me good flexibility. Thanks for the recommendation!

 

[wongster360]

I recently came across a new juice that I really liked. Being lazy that I am, I didn't feel like vaping down the 3/4 bottle of juice that I had so just dry fired it a couple times and dripped from there out. (Using a cyclone) sooner or later I'll decide to finish that bottle


Sent from my iPhone using Tapatalk 2

 

[karmakatie]

You could just temporarily plug the RM2 deck hole. If you still have cartos around take and use the end cap from it might have to cut it down a bit, but the silicone would be safe to vape with.

 

[patrao_n]

Now sure where you are saying where to put the silicone sleeve. But what I did recently is plug the hole in the deck with cotton. I had to put the rm2 on another mod because I didn't want to melt anything on my reo. Worked pretty well.

Sent from my SM-N900T

 

[Rev. Stabard]

You could just temporarily plug the RM2 deck hole. If you still have cartos around take and use the end cap from it might have to cut it down a bit, but the silicone would be safe to vape with.

Lot's of good suggestions here, thanks! I think I'll go with the Igo and see how that works out (especially since I've already ordered it ) but it's good to have options if I'm out somewhere and want to try a different juice using my mini.

 

[Rickajho]

Speaking of... is anyone out there using a Vision Eternity RBA on their Reo? Or was that Eternity thing just a really bad idea in general?

 

[JC Okie]

I tiered one once and just didn't like it. Although it can be fed from the bottom, it's not really meant to be a bottom feeder. I didn't like it because it has a big "well" that holds juice, and it gurgled for me. I had to stuff a lot of wick down in it.....didn't like that. And, lastly, I didn't really like the way it's set up....no post screws -- just those little cap things that hold the wire on the posts. But that's just me.