I just bought a KP Long Barrel atomizer at 2.0ohm and Im going to set it up on my vision spinner 2. Anyone have any experience with dripping? its going to be my first time and I just hope dripping brings out the flavor in ejuice. All my ejuice flavors are muted when I put them in my glass clearomizer.
Dripping Question
- Thread starter nfields5
- Start date
- th_trl_thread_readers 0
- Status
Here is a great blog post on dripping by ECF member The Ocelot: Drip, Drip, Drip - The Sound of Dripping.
I'm not familiar with that atty so I looked it up. It appears to be a bridgeless atty, that's great for flavor. It will however not hold quite as many drops as one with a bridge does.
Not being familiar with that particular one the first thing I would do is make sure any priming fluid is out of it. This is done with PG, VG or the juice you intend to use first. Make sure you have a paper towel, then drip 4 of 5 drops in the atty and then gently blow it out from the top. It will come out the holes above the 510 threading so make sure you have the paper towel ready. Do this a couple of times and your ready to go. This is also the same process done between flavors but only using PG or VG.
Now you're ready to vape so 3 or 4 drops should do it. If it is leaking out the holes by the threads you have put too much in, you can blow a bit out as described above. When your vape gets a bit dry add a few drops. It takes a little getting used to but the flavor should be awesome.
Not being familiar with that particular one the first thing I would do is make sure any priming fluid is out of it. This is done with PG, VG or the juice you intend to use first. Make sure you have a paper towel, then drip 4 of 5 drops in the atty and then gently blow it out from the top. It will come out the holes above the 510 threading so make sure you have the paper towel ready. Do this a couple of times and your ready to go. This is also the same process done between flavors but only using PG or VG.
Now you're ready to vape so 3 or 4 drops should do it. If it is leaking out the holes by the threads you have put too much in, you can blow a bit out as described above. When your vape gets a bit dry add a few drops. It takes a little getting used to but the flavor should be awesome.
I heard your not supposed to blow from the top because that hurts the coils. I think your supposed to blow from the bottom
As long as you aren't blowing out tropical storm force winds, the atomizer will be fine blowing from either end.
I've used a lot of those type of atomizers, in fact that all we used a few years ago. I've never hurt one by blowing gently into the top. There is one maker (HH357) I know of that recommends blowing his from the bottom. I suspect is has to do with how he wicks it not the coil.
Your atty your choice.
- Status
Similar threads
- Locked
