Dripping with an Ego Twist

[cocacola31173]

What exactly would you need to drip with a Ego Twist and what is the purpose of the cones? Does the drip tip go on top of the cones? What is the purpose of a short cone and what would you use them for? I want to experiment with dripping and need to know all what I need. Also what would make a Ego look good if using cartomizers? Would you use a cone for them?

Thanks!

 

[MattBott]

Cones are used for ascetics only. They cover the "eGo Threads" and / or cartomizer.

For dripping, I would recommend a shorty 510 extender, atomizer, and drip shield.

The 510 extender so you don't get juice all over your twist's thread's and 510 connector in case you over drip (you will over drip if this is your first time). The drip shield contains the over dripping so it doesn't leak all over your battery and acts as a heat sink since these can get pretty warm.

Here's what I'm using at the moment:

• 1.5ohm 510 Atomizer Take the plastic parts off of the top (it was built for using a cartridge)
• 510 Extender (remove the washer)
• Drip Shield

Here's the setup I use. I was trying to find a link to the simple thread cover that I use, but I couldn't. The drip shield slips nicely behind it:

Note: I don't have a twist, but its all the same from the button up. Since you are using a twist, I'd recommend a higher resistance atty. Maybe a 2.0 or 2.5. In my experience, 1.5 is perfect for the 3.7ish volts I'm getting, but pusing the 2amp limit of the device.