Dripping?

Status
Not open for further replies.

Kaezziel

Supreme Overlord of Everything
ECF Veteran
Verified Member
Jul 29, 2014
4,536
47,824
Houston, TX, USA
They'd work beautifully on an MVP, ER.
They work perfectly fine on anything with a 510 connection.
The upside of using it on your MVP is that you can adjust the power level so that it'll give you the vape that you are looking for.
Start with the low end of your voltage/wattage and bump it up until it gets to where you want it. :)

Hope that was helpful...
 

KB3100

Full Member
Oct 7, 2014
8
3
Maryville, TN
LMAO!! Yeah... now throw all that stuff in a drawer somewhere and forget about it... spend a crap-load of money on mechs, regulated mods, rebuildable drippers, genesis tank, carto-tanks, DIY juice supplies, tons of 18650 batteries, a couple 26650 batteries, 18350 batteries, more cartos, more juice, carry cases, 510 stick batteries, 510 PCC (charging case), tea bags, cotton, wire, rayon.......... then you'll be close to where I'm at.... :D

Somehow, though... I still think I'm saving money. Kinda like when a woman goes into a shoe store and buys 20 pairs of shoes because "They're On SALE!!"...... :facepalm:



I went went to a few local Vape shops today..... Showed them the one in the link you gave me... One guy looked at me like I was stupid and the other guy said no... And the website you gave me is out of stock and one guy said he could build me 1 for $110 the cheapest lmao
 

Stosh

Vaping Master
ECF Veteran
Oct 2, 2010
8,921
16,789
74
Nevada
I went went to a few local Vape shops today..... Showed them the one in the link you gave me... One guy looked at me like I was stupid and the other guy said no... And the website you gave me is out of stock and one guy said he could build me 1 for $110 the cheapest lmao

Yup, local vape shops can be like that, I have fun with them when I walk in with atomizers, cartos and other old school vape equipment....:)

Some good dripping attys can be had here.....LR510 Low Resistance Bridgeless 2.0 ohm Sealed Post Atomizer (Cisco Spec) - Avid Vaper

At 2.0 ohm, it should work well with your battery, and being bridgeless easy to drip and clean.
 
Status
Not open for further replies.

Users who are viewing this thread