dry hits with phoenix carto

[Aal_]

I have a phoenix carto bottom coil. I filled it with boba's bounty. I take one draw its fine. The second one is dry. Is there a way to make it work. I chose a bottom coil so that it works with heavy liquids. Its like I need to keep it sitting for an hour to get only one decent draw. Its the one with a sleeve from gotvapes.

 

[Dimitris]

I would suggest you dilute your eliquid with 10% distilled water. Also take a few dry pulls on the carto before you activate the switch to feed the atomizer. Bobas is pretty thick so its having a hard time keeping up with your vape pace.

 

[Harplayr]

That's exactly what I had to do with Boba's. It's a very thick juice. I found that just a few drops of distilled water did the trick.
Another thing to try is to lift the center air tube just slightly to allow more flow. If you lift it too much though you could get leaks.

 

[Mroutlaw]

I have a phoenix carto bottom coil. I filled it with boba's bounty. I take one draw its fine. The second one is dry. Is there a way to make it work. I chose a bottom coil so that it works with heavy liquids. Its like I need to keep it sitting for an hour to get only one decent draw. Its the one with a sleeve from gotvapes.

you can either dilute your juice a bit or raise the center airtube just a hair. Here is a video that shows you everything you need to know about the ce3 (Phoenix). I demonstrate on the Smokeless Image version, but it is the same exact device, just in 808 threads. It comes from the same factory.

Smokeless Image CE3 Cartomizer - YouTube