On a whim I built a dual setup for my Fogger v4 with uneven coils (already had one laying around so I used it and just balanced to my desired value with the other). One at 1.3Ω over 2.0mm, the other 0.7 on 1.4mm form; 1.0Ω resultant –on the dot. On dry firing them the higher is slower while the lower is faster (no brainer there <g>). Wicked both with cotton and assembled. Getting thick & full of flavor vapor air flow set at with about 30% (pull sensation, I don't have a vacuum meter! <vbg>). Not sure which coil is which; flavor/steam volume.
I know many of you have done this and whith creative wicking combos (silica, cotton, mesh, mesh sleeved silica or cotton, etc...) as well as different placement or styles (twisted/plain, vertical/horizontal...), can/will you share your experiences and photos of your most interesting builds?
TIA,
4Dive (Jorge)
I know many of you have done this and whith creative wicking combos (silica, cotton, mesh, mesh sleeved silica or cotton, etc...) as well as different placement or styles (twisted/plain, vertical/horizontal...), can/will you share your experiences and photos of your most interesting builds?
TIA,
4Dive (Jorge)
