e-Go repair tip

[Jrdot]

I'm sure most of you are aware that occasionally the "button" on e-Go batteries which is suppose to make contact with your clearomizer or whatever, will sometimes need to be pulled up a bit. I discovered the small screw driver used to repair eyeglasses is just about right to pry it back up. They are small, inexpensive, and easy to carry. I found myself out with only the one battery and going thru my glovebox I saw the cheap repair kit. 3 minutes later I was vaping again. Hope this is useful to someone.

 

[cope]

i think your refering to the 510 connection pin not the fire button or am i wrong but thats a goot tip

 

[Jrdot]

Thats it LoL Not the button you push to activate the device.

 

[omyeyes]

It's normally referred to as a "pin."

 

[Iffy]

It's normally referred to as a "pin."

Also 'positive' or 'center contact'.

 

[DavidOck]

I'm positive it's the center contact...

 

[D. Waterhouse]

Circuit Board Spacer If it's a constant problem drop one of these in the connector.

 

[omyeyes]

Circuit Board Spacer If it's a constant problem drop one of these in the connector.

They should have included one of these with the MVP. I'm ALWAYS having to pull the pin on that one!

 

[billiam]

Just be sure and turn it off before sticking anything down in there and accidentally hitting the fire button. Like I did.