E liquid samples

Status
Not open for further replies.

VapnWitch

Super Member
ECF Veteran
Feb 6, 2013
834
667
VA, USA
I've never had any that tiny, but try warming it up a little bit. Putting it in your pocket for a little while should work fine, but if you're in a rush you can drop it in some very warm water for a couple of minutes and see if it pours easier that way. In my experience, cold e-liquid = thicker and harder to get out of the bottle e-liquid, especially if it's high VG (which is already thicker than high PG).
 

Mohamed

Super Member
ECF Veteran
Aug 15, 2013
876
505
USA
Yeah I've never had any 1 ml samples either...3 ml is the smallest I've seen. I guess the best you can do is just keep squeezing and hope it all comes out. You may be able to pop the top off as well and pour it in that way. The part that looks like an eye dropper on the top of the bottle...usually you can press that with your thumb and it will pop off. That will leave you with just the bottle and a circle opening at the top. That should be easier to pour and I do that with 30ml bottles when I can't get out the last few drops. It's kind of like toothpaste you can work with the tube for weeks and still get a little bit more out of it ;)

http://www.e-cigarette-forum.com/fo...cussion/458263-3ml-cheap-sampler-bottles.html I started that thread about 6 months ago when I started. It was recently revived from the dead so if you are new and want to try many vendors and many flavors for a reasonable price you may be interested in that. Only reason I think you're new is that you only have 11 posts...so welcome to ECF.

If you got any questions just make a post and you should have an answer in a few minutes to a half hour. I've found everyone to be friendly and helpful around here. Aside from the minor political arguments it's a safe, fun, and informative place to be ;)
 

alisa1970

Vaping Master
ECF Veteran
Mar 30, 2013
3,122
9,799
54
Portland, OR
I bought 9 of them, had the same problem. What are you trying to pour them into? I am using evods, so I would have to tilt the vial completely upside-down with it resting just on the outer edge of the clearo (clearo turned almost 90 degrees sideways). Usually the vapor seal would release, and the whole vial would spill in. If that didn't happen, I had to use a toothpick to break the vapor lock.

I will say that the first time this happened, I lost almost the whole vial. I did get enough to vape for a little bit.

Edit: sorry, didn't read your post thoroughly re: what you were using. But yeah, I had that problem too. :)
 
Status
Not open for further replies.

Users who are viewing this thread