E1 Error for Too Tight?

[SimboSlice]

Hi,

I get an E1 if my Phoenix rba is too tight? It's kinda annoying since its not tight at all. I have to keep it barely snug so a slight push on the Atty will make it loose. Is there a fix for this?

 

[adeline]

Are you sure it's because it's too tight?

E1 – Short Circuit / Shorted Atomizer – If this error appears, remove the atomizer and replace with a different one or lower your voltage settings The ProVari will automatically reset when the problem is fixed or lower your voltage settings. The ProVari will automatically reset when the problem is fixed.

 

[spraintz]

the center/positive pin on the phoenix is a "floating" pin and plate, too tight the it could be pushing the post that the coil attaches to into the outside/ground section of the atty causing the short.......but make no mistake....E1 is because of a short.....