Easy fixes for kayfun lite fill screw leakage?

[ntimmy]

I have this one kayfun lite clone ( i know i know just but an authentic and you wont have these problems ) that has been nothing but a pain in my ....., first the plastic tank cracked and i was getting all kinds of air hole leakage from it not vacuum sealing. Now i got that fixed my fill screw leaks all over my mech mods ( because there is no way im putting it on a VV/VW ) and im assuming I am even getting vacuum leaks from that. I do not have a gasket that is small enough and i have tried to wrap cotton around to act a somewhat of a gasket. So short of permanently gluing the screw in and top filling it is there any other suggestions? I also don't even know what kind of clone it is i got it in a impulse buy at a B&M....


Secondary note im going to get an authentic kayfun soon Lite Plus or 3.1? Canadian suppliers? your thoughts?

 

[Scy123]

Dashvapes in Canada has authentic Kayfun Lite Plus
DashVapes - SVOEMESTO KAYFUN LITE PLUS

If you have an evod/protank atomizer or similar device with one of these insulators you could cut them up and use them as a gasket. Or you could buy one and cut it up it's only $2

Personally I use oversized #004 orings and undersized M2.5X6mm pan head screws works really nice.

 

[ntimmy]

Dang man! that insulator trick is genius i had one on my vape station sitting right in front of my face from "attempting" to rebuild aspire bvc coils. Much appreciated! I was looking at the Kayfun on Dash Vapes and i think that seems like the most reputable site in Canada to get them from. Thanks again!

 

[Scy123]

Your welcome!