Ecf
- Thread starter Bash05
- Start date
- th_trl_thread_readers 0
- Status
Welcome. Going to need more details to determine if theirs a problem.
The other ingredient most use is PG, this thins the juice and makes it less thick. You can make juice solely using VG and flavouring. The juice will be very thick though so unless using the 'right' coil/tank, may find coils gunking up quite fast and getting dry hits as cotton can't wick enough.
It all depends on your setup. I use 80% VG and 20% PG but I use RTAs so even if does get gunked up, it's a very easy fix but it has yet to happen.
It all depends on your setup. I use 80% VG and 20% PG but I use RTAs so even if does get gunked up, it's a very easy fix but it has yet to happen.
If it is working right for you, that's all that matters. VG has a slightly sweet taste to it so if you do ever add PG to a recipe you used in the past, it may taste slightly different.
No side effects or health issues though by leaving out the PG and going 100% VG.
Great thing a bit DIY, you can make it to suit you.
The third typical ingredient is PG (propylene glycol) and it's mostly used to give "throat hit" (less smooth) and thin the liquid. If your liquid is wicking well to the coil - so you don't get "dry hits" then it is FINE to use just VG and flavoring. You'll get more "clouds" with mostly VG, too.
What percentage flavoring - and what KIND of flavoring are you using?
Just want to make sure it's flavor that's good for vaping. And if it is - it's USUALLY based on PG - so you have a little of that in your mix after all...
What percentage flavoring - and what KIND of flavoring are you using?
Just want to make sure it's flavor that's good for vaping. And if it is - it's USUALLY based on PG - so you have a little of that in your mix after all...
Welcome and glad you joined. Keep it simple, follow below and you should be successful.
Might like to read: Tips for Beginners – DIY OR DIE
Could read the stickies in this forum:
DIY E-Liquid
- Status
