Ego Carto Help

Status
Not open for further replies.

The Big Chief

Moved On
ECF Veteran
Dec 14, 2009
1,721
433
Anderson, IN
No, you dont need needle, but it does help. You can fill slowly from threaded end, or you can pop the center mouthpice off, by sticking something in the hole and tilting to the side, and do teh same with next little piece you see underneath that. Then puncture that lil hole you see in dead center..thats fill hole. You can do a drop at a time in there too. BUT, be sure to lay it on its side and spin around every 10 drops so it fills all over inside. That whole tube is hollow except for batting. Be sure you wet up all of it, and will take about 2 ml, at 2.5 it will leak out whichever end is down. :)
 

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
Answered my own question....These cartos are great even @ 6+ V's Very handy and enjoyable !! LOVE it !!

It's a 2.5ohm carto...you're a brave man. LOL I would definitley do them at 5v cause I'm a nut job, but 6v is just insanity! You insane person you. ;) Glad it didn't fry. They do kinda rock...I just can't stand the mouth piece.
 

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
depends... do they have a soft tip? if so then just pop it out.

if not then just fill up the rubber cap it came with (only about a quarter of the way to half way) and push it in connector first.

Different animal entirely. eGo cartos are giant and designed completely different than the cartos you're thinking of. I wish you COULD cap fill them!
 

Ciego

Ultra Member
ECF Veteran
Nov 29, 2010
1,100
669
A dank basement in SE Minnesota
If the carto has a hard cap instead of the soft rubber one, you might be able to soften the glue holding the cap in place by running the carto end under some hot tap water, then *gently* prying around the cap with a bent paper clip or small nail.

Otherwise, you can not only use the condom method (filling the protective rubber thingy 1/4 - 1/3 full of juice, then gently and carefully inserting the carto into the cap connector end first).

Here's another idea. You can get syringes with a soft, flexible plastic "needle." It's not a sharp, and unless the juice is super-thick, you'll have no trouble inserting the flexible plastic needle into the hole in the mouthpiece and filling it that way.

HTH
 

warlike36

Ultra Member
ECF Veteran
Verified Member
Mar 13, 2010
2,142
652
54
Seymour,IN.
It's a 2.5ohm carto...you're a brave man. LOL I would definitley do them at 5v cause I'm a nut job, but 6v is just insanity! You insane person you. ;) Glad it didn't fry. They do kinda rock...I just can't stand the mouth piece.


Really.:)..Honestly..:).It runs great !! Doesn't taste burnt..no flames..just a good vape :p:p

You have a wonderful day Biaca !!
 

Kellyinbr

Super Member
ECF Veteran
Verified Member
Nov 18, 2008
731
1
South Louisiana
I was sent on buy a great person and I am in love with it...I am about to order a crap load of them..Makes it easy not to have to worry about my liquid all day long and with no burnt taste at 3.7v..the E2s give me burnt taste often, these do not..I am using my hubbys lil chuck (cant find my 2) and a nico stick with an adapter to raise it up for airflow and it works great
 

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
A lot of the times those will burn up really fast even at 3.7 for me. When you do get a good one though it's really good for a long time. It's kind of hit or miss so I stopped buying them so much.

I've had all of 4 of them. Two fried at 3.2v on the first hit...and yes they were full. The two that did work, worked extremely well. But yes, very hit and miss.
 
Status
Not open for further replies.

Users who are viewing this thread