eGo One Mega V2

[fuco312]

Hello there fellas ! I've decided to kick cigarettes out of my life and start vaping. It's been 23days so far without any cigarette and I've decided to upgrade my eGo-T to eGo one mega v2. I've ordered whole kit and I'm really into DIY stuff, so I also bought CLR coil head and Kanthal A1 0.3mm wire + some japanese cotton. I've emailed Joyetech about some specific info which I wasn't able to find out there. The constant voltage mode is at 3.6v (in cause someone is curious). But to the point: What is the lowest resistance possible to run on the battery ? I've been told by couple of people on reddit, that it can handle coils only up to 0.5ohm, but some of them were saying that it can actually fire coils up to 0.2ohm. Is there anyone who has tried coils with lower resistance than 0.5 ohm ? Thank you for responding !

 

[salemgold]

Congrats on kicking the smokes to the curb

This manual may help you to find the answers that you seek. Good luck.
download - Joyetech

 

[Dieseler]

Welcome to the forum.
That device according to what i read will fire between 0.15-3.5 ohms .

 

[fuco312]

Thank you for info guys ! Also thank for the user manual link I somehow managed not finding it on the site I'll try building less than 0,5ohm on the CLR head just for fun if it really works, but first I gotta get ohm meter in my mailbox ! Thank you again

 

[Dieseler]

Fuco nice thing about forum is folks willing to help and share idea's etc.
Good luck in your coil building its fun and ask if you need help.