- Status
My guess is that your friend is drawing a bit too hard and pulling the juice up.
Your friend may also be vaping faster, thus not allowing the juice to hit the atomizer.
These are only guesses. Hopefully someone will come along with more info for you.
Happy 4th of July and Happy Vaping,
Paula
Your friend may also be vaping faster, thus not allowing the juice to hit the atomizer.
These are only guesses. Hopefully someone will come along with more info for you.
Happy 4th of July and Happy Vaping,
Paula
For the ego-t, some tips that help me.
-Remove cart periodicly and wipe off any fluid on it and allow air bubble to rise to release negative pressure.
-Remove both pieces inside mouthpiece for a better draw.
-Periodicly remove cart and look into atomizer, if juice is seen at very bottom its best to remove it due to two reasons.
1, when ecig is laid down on its side or turned upside down, that juice flows into air pathways in cartridge.
2, too much in there seems to eventually leak into battery after time.
To remove juice in bottom of tank atty, i turn it upside down into paper towel and shake/flick it until juice is gone, then wipe out with a cuetip.
BY doing this I never have juice in the mouthpiece or in my mouth.
-Remove cart periodicly and wipe off any fluid on it and allow air bubble to rise to release negative pressure.
-Remove both pieces inside mouthpiece for a better draw.
-Periodicly remove cart and look into atomizer, if juice is seen at very bottom its best to remove it due to two reasons.
1, when ecig is laid down on its side or turned upside down, that juice flows into air pathways in cartridge.
2, too much in there seems to eventually leak into battery after time.
To remove juice in bottom of tank atty, i turn it upside down into paper towel and shake/flick it until juice is gone, then wipe out with a cuetip.
BY doing this I never have juice in the mouthpiece or in my mouth.
BCman gave you lots of good tips when you get liquid in your mouth with an eGo-T, but there are a few more things you can check or do. This thread has most of them
http://www.e-cigarette-forum.com/forum/atomizer-issues/173123-leaking-issues-ego-t-tanks.html
http://www.e-cigarette-forum.com/forum/atomizer-issues/173123-leaking-issues-ego-t-tanks.html
if none of that works, wick might be too far down, disassmble and push the wick SLIGTHLY UP. (might as well do a clean up if you're there)
You can prevent this by pre-firing the atty for a second or 2 before starting your draw. Just hit the button a bit before you start to drag on it. It gives the atty a chance to heat up and vaporize the juice in the atty before you suck it up. Also a long , slow gentle pull helps too. 
I'm just gonna come out and say this. After using the tank for 6 months, you're probably gonna get tired of it and all of the fiddly issues. I recommend getting the ego mega dual coil cartomizer from madvapes.com. They're awesome. Just fill and vape, so fuss. No I don't work for them. But I'm happy to buy something and it work 100% the first time I buy it.
- Status
Similar threads
