Hey there guy's i recently bought the EA clone and the voltage drop is very minimal but i've been testing it under load at .2 ohm load and its almost a 1v drop. So i'm curious on the any other owners of the EA clone and what they have experienced
Ehpro EA clone Help
- Thread starter corsairhawkvap3
- Start date
- th_trl_thread_readers 0
- Status
Under load depends on the resistance of the clearo, carto or rba your using and has nothing to do with the function of the device. Using a .2 ohm resistance (which is dangerous) should have a higher voltage drop than one volt because it's pulling 20A. 20A is over what most batts can handle and at the limit of what only a couple of others can handle, and I know of only one that's 30A. The EA Clone isn't what you should be worrying about.
I fully understand what your talking about but i've tested my m16 brass clone at .2ohm load and its around .5-.6 drop while my EA clone is almost a 1volt drop. Then i tested both mods again with same battery and same atty at .37ohm and the volt drop is identical xD
- Status
Similar threads
