EHPro Kayfun 3.1
- Thread starter ohman_86
- Start date
- th_trl_thread_readers 0
- Status
Yes, why plug it ? You should just pour your juice in the tank.....not in the center chimney tube. Its pretty darn easy.
The kayfun tank is massive its impossible to get any juice down the chimney unless you are filling it with watering can.
just fill it like this from the top Nick's RBA Reviews...The Kayfun 3.1 by Svoemesto vs The Kayfun 3.1 by EhPro Clone - YouTube
If its anything like the real KF 3.1, cover the airhole (between the air adjustment screw and fill hole) with a finger, remove top cap, and fill (leaving a 1/8" or so airspace between juice and top cap). Screw back on top cap until it just catches, then remove finger from air hole while turning the entire unit upside. Wait until bubble rises, turn upright again, and all should be good.
I agree, if your filling it from the top do this.
once you have the top cap removed and the tank is filled, plug the air intake hole and screw the top cap on one turn. Then quickly remove your finger from the air hole, turn it upside down and finish screwing the top cap on. It won't leak that way and it won't ever flood.
I've been doing it this way forever, well since I've had Kayfuns.
once you have the top cap removed and the tank is filled, plug the air intake hole and screw the top cap on one turn. Then quickly remove your finger from the air hole, turn it upside down and finish screwing the top cap on. It won't leak that way and it won't ever flood.
I've been doing it this way forever, well since I've had Kayfuns.
BTW, I did see a short video a while ago where someone used a whittled-down cut-off chopstick (!!) to plug the drawtube after the drip tip had been removed. He pulled off the topcap, refilled, and replaced the topcap without putting his finger on the airhole or inverting. It seemed to work well, i.e., no flooding.
Hmm, yeah, flipping the kayfun makes filling it so much harder, lmao. Seems like plugging the chimney and all is a bit more work than using my finger to cover the air hole and flipping the tank. But hey, what do I know, I am just an old man and set in my ways. Plus I never misplace my fingers, tools tend to disappear or the cats take them away to play.
Well it doesn't seem to be an easy way to fill seen as tho you have to start thread because you are having problems filling it.
Men men lycka till
seriously guys i know how to fill it from the top, that wasent my question, i 've found a way so you dont need to tilt it after you thread it and it works for me, so please leave your insulting comments for yourself unless you wanna answer the actual question
som sagt BaDaBooM jag vet hur man fyller det var inte min fråga
som sagt BaDaBooM jag vet hur man fyller det var inte min fråga
Nobody is trying to insult you or put you down, we were just wondering why would choose a awkward way to fill it.
Suppose you could plug it with a drill bit (not the cutting edge side) then you can still screw the top on and pull it out after you have screwed the top on.
Vårt i Sverige bor du ??
After reading all coments i saw wait for "bubbles" and now it works useing that metod rather then useing the one i was thinking of thanks guys, it sounded insulting but i guess that wasent your intention sorry
Örebro du?
Everybody is learning here that's why a lot people question everything, I suppose it could come off as rude, there is no "handbook" to vapeing.
22 år i Lund nu bor jag flyttat till England.
- Status
Similar threads
