EHPRO Omega will not read on MVP2

[Toombstoned]

I have been recoiling my protank with micro coils at around 1.3 ohms for a while now. I just got an Omega clone and have tried several coil builds but when I try to ohm check I get "non" on both my MVP2 and my Itaste v3. Anybody know what the problem is?

 

[suspectK]

Remove the legs of the coils in center post, and loosen the 510 screw. If eh pro has post holes or want to use them, you'll have to loosen to the point where they face the correct direction.

 

[Thayamax]

I had the same problem with mine, but the 510 connection doesn't have a screw slot. I got it to work by using a Kanger airflow controller attached to the bottom of it to make contact. Fortunately it works without it on my sigelei 20W with the floating pin.