Eleaf GS Air Fan
- Thread starter Javamon
- Start date
- th_trl_thread_readers 0
- Status
Well here it is with half a tank of Honey Tobacco already gone. Running at 10W on the iPOW2 the flavor is good with the stock silica coils and I was actually quite surprised with the vapor production. I'll see if I can yank a coil apart this weekend for a little Rayon transplant with a 30g micro coil.
When it comes to flavor I have been really spoiled by the Origen Dripper V2 (Single 24g @ 0.5Ω Rayon wick) and the Origen Genesis V2 (Dual 26g @ 0.5Ω Mesh wick), there is nothing I have tried so far that can touch these two for yum factor!
My remaining flavor tree:
The Rose V2
Flash e-Vapor VS
Flash e-Vapor V3
NextGen
Kayfun V4
Silverplay
Kayfun Lite & 3.1
GS Air-M (Stock coils)
Kayfun mini 2.1
Redoing the coil could bring the M up one place and possibly two.
The only problem I have with this is the sloppy airflow control ring and it makes noise when wide open. I wasn't going to apply the pliers to the ring like I have seen posted before so there has to be something else. I don't think the stop pins come out easily to get the AFC ring off and I know it is going to annoy me till it is tightened up. OCD... OCD... OCD...
It had the chromed brass Kanger Genitank look when I took it out of the package and the AFC ring almost felt like plastic. I will give it a fair evaluation over the next while and see how it holds up.
So I'd like to thank you all for recommending the GS Air!
When it comes to flavor I have been really spoiled by the Origen Dripper V2 (Single 24g @ 0.5Ω Rayon wick) and the Origen Genesis V2 (Dual 26g @ 0.5Ω Mesh wick), there is nothing I have tried so far that can touch these two for yum factor!
My remaining flavor tree:
The Rose V2
Flash e-Vapor VS
Flash e-Vapor V3
NextGen
Kayfun V4
Silverplay
Kayfun Lite & 3.1
GS Air-M (Stock coils)
Kayfun mini 2.1
Redoing the coil could bring the M up one place and possibly two.
The only problem I have with this is the sloppy airflow control ring and it makes noise when wide open. I wasn't going to apply the pliers to the ring like I have seen posted before so there has to be something else. I don't think the stop pins come out easily to get the AFC ring off and I know it is going to annoy me till it is tightened up. OCD... OCD... OCD...
It had the chromed brass Kanger Genitank look when I took it out of the package and the AFC ring almost felt like plastic. I will give it a fair evaluation over the next while and see how it holds up.
So I'd like to thank you all for recommending the GS Air!
linda, lynn is using a mobile device - iphone? - and the necessary app might not be free
Thank you for posting your review!Well here it is with half a tank of Honey Tobacco already gone. Running at 10W on the iPOW2 the flavor is good with the stock silica coils and I was actually quite surprised with the vapor production. I'll see if I can yank a coil apart this weekend for a little Rayon transplant with a 30g micro coil.
When it comes to flavor I have been really spoiled by the Origen Dripper V2 (Single 24g @ 0.5Ω Rayon wick) and the Origen Genesis V2 (Dual 26g @ 0.5Ω Mesh wick), there is nothing I have tried so far that can touch these two for yum factor!
My remaining flavor tree:
The Rose V2
Flash e-Vapor VS
Flash e-Vapor V3
NextGen
Kayfun V4
Silverplay
Kayfun Lite & 3.1
GS Air-M (Stock coils)
Kayfun mini 2.1
Redoing the coil could bring the M up one place and possibly two.
The only problem I have with this is the sloppy airflow control ring and it makes noise when wide open. I wasn't going to apply the pliers to the ring like I have seen posted before so there has to be something else. I don't think the stop pins come out easily to get the AFC ring off and I know it is going to annoy me till it is tightened up. OCD... OCD... OCD...
It had the chromed brass Kanger Genitank look when I took it out of the package and the AFC ring almost felt like plastic. I will give it a fair evaluation over the next while and see how it holds up.
So I'd like to thank you all for recommending the GS Air!
View attachment 462222
I think it will rank higher after a rebuild with rayon...
I almost always use an ipad or iphone to come on here and there are nevern any adds (except for an "ad" thread). I use tapatalk to get in here and not the actual website, could that be a difference?
very possible, but then tapatalk got its shortcomings too .........
Rather than photos that might not be all that clear, I made some crude drawings of how I modified the GS Air coil caps to CLR.
First, the unmodified cap. Then the cuts made with aviation snips.
The cuts are made on both opposite sides of the cap.
The finished cap with the enlarged, extended slots broken out and the other slots covered with epoxy.
To use, wick the coil without trimming. Slip the cap on so the slots go over the wick, press the cap on, then trim the wick ends fairly close to the cap.
The snips distort the metal a little bit, I just squeezed it back to round on a drill bit with pliers.
I don't usually replace the coil once I rebuild, I just burn and re-wick.
The blob! It lives!
First, the unmodified cap. Then the cuts made with aviation snips.
The cuts are made on both opposite sides of the cap.
The finished cap with the enlarged, extended slots broken out and the other slots covered with epoxy.To use, wick the coil without trimming. Slip the cap on so the slots go over the wick, press the cap on, then trim the wick ends fairly close to the cap.
The snips distort the metal a little bit, I just squeezed it back to round on a drill bit with pliers.
I don't usually replace the coil once I rebuild, I just burn and re-wick.
The blob! It lives!After hearing all the complaints about tapatalk I'll just put up with the ads...I don't mind seeing them it's only when I go to click on one thing and click on the ad accidentally that it bugs me. But...at least the ads do open in a new tab!! Lol
Thank you, makes it very clear what you did.
So by doing it this way, you don't have to wrap the gauze around the coil before putting on the cap correct? Does the epoxy depart any flavor to the wick? Do the components of the epoxy actually leech into the juice itself?
This is the UV kit I was thinking of:
Bondic® The World's First Liquid Plastic Welder! Bond, Build, Fix and Fill Almost Anything in Seconds! Your Hard Fix For Sticky Situations. (Bondic® Starter Kit):Amazon:Office Products
I may just order this 'cause it's cool:
Bondic® The World's First Liquid Plastic Welder! Bond, Build, Fix and Fill Almost Anything in Seconds! Your Hard Fix For Sticky Situations. (Bondic® Starter Kit):Amazon:Office Products
I may just order this 'cause it's cool:
Why? You want some kolliflower don't cha?? Go on...you can admit it here. We won't tell anyone!! Mum's the word..Back to kolliflower...now I don't want to eat my granola.
Raw with dressing. Cooking it is a travesty! Cooked, foosha kolliflower is the debbil!Why? You want some kolliflower don't cha?? Go on...you can admit it here. We won't tell anyone!! Mum's the word..
You know you love it! It's BEAUTIMOUS!!Why? You want some kolliflower don't cha?? Go on...you can admit it here. We won't tell anyone!! Mum's the word..
And you can turn it into THIS!!!
One only has to HIDE the cauliflower under enough bacon, cheese, sour cream and onions. VOILA!
Morning report
Yesterday our very own Nanny stopped by to give the guys another well-deserved dope slap for acting like overgrown rascals, and to report on a case of gurgle-itis. Cheech suggested doubling the washers on top of the coil. Cheech is wise, especially after he's slugged down his cauliflower puree with powdered nutmeg. This morning I had an M gurgle, even after the usual condensate swab. I doubled the washers and the gurgles went back to Michigan, where Nanny will find them in her Rice Krispies.
Cheeche'spurple fooosha cauliflower puree
Yesterday our very own Nanny stopped by to give the guys another well-deserved dope slap for acting like overgrown rascals, and to report on a case of gurgle-itis. Cheech suggested doubling the washers on top of the coil. Cheech is wise, especially after he's slugged down his cauliflower puree with powdered nutmeg. This morning I had an M gurgle, even after the usual condensate swab. I doubled the washers and the gurgles went back to Michigan, where Nanny will find them in her Rice Krispies.
Cheeche's
Last edited:
- Status
Similar threads
