Eleaf GS Air Fan

Status
Not open for further replies.

IMRs

Vaping Master
ECF Veteran
Verified Member
Sep 15, 2013
4,047
32,426
Penn's woods
Might want to run a Q-tip down the air pipe, remove the coil and blow through it to remove extra juice.
Have you been using the same coil all this time?
Yes, well I've been rotating between this and 2 other Nauti minis. But yeah, it's the same coil since Apr. 3rd. :)

ETA It's running fine now. Maybe it got a little gunked. Next time I will take the coil off. I did everything but that. Thanks Cheech! :)
 
Last edited:

Cheechako

Vaping Master
ECF Veteran
Verified Member
Feb 11, 2012
5,192
39,314
Arizona
Yes, well I've been rotating between this and 2 other Nauti minis. But yeah, it's the same coil since Apr. 3rd. :)

I was just thinking maybe the condensation was building up in the air tube to the drip tip...
I can't remember who posted that this was a problem for them.
Hope this helps! :)
 

GranFumador

Ultra Member
ECF Veteran
Sep 12, 2013
1,607
17,647
Peoples' Bucolic Republic of Maine
I've had my GSA a little over a week now. I was wondering why I'm getting some flooding (tightness and 'gurgly') now. The air flow screw is out of it. All of my ejuices are mostly light. Just wondering if it's time to change the coil?
I sometimes get gurgles in the morning. Turns out it's mostly condensation. In addition to Cheech's good advice, I
1) pull the drip tip, blow through it onto a tissue
2) use the tissue or a Q-tip to dry the cavity the tip plugs into
3) check the bottom of the tank and the top of the battery for any condensation... though these are usually dry.
 

IMRs

Vaping Master
ECF Veteran
Verified Member
Sep 15, 2013
4,047
32,426
Penn's woods
I sometimes get gurgles in the morning. Turns out it's mostly condensation. In addition to Cheech's good advice, I
1) pull the drip tip, blow through it onto a tissue
2) use the tissue or a Q-tip to dry the cavity the tip plugs into
3) check the bottom of the tank and the top of the battery for any condensation... though these are usually dry.

Yes, It probably was. It happened first thing this morning. I guess it was in sleep mode. :laugh: Thanks again!
 

Cheechako

Vaping Master
ECF Veteran
Verified Member
Feb 11, 2012
5,192
39,314
Arizona
I sometimes get gurgles in the morning. Turns out it's mostly condensation. In addition to Cheech's good advice, I
1) pull the drip tip, blow through it onto a tissue
2) use the tissue or a Q-tip to dry the cavity the tip plugs into
3) check the bottom of the tank and the top of the battery for any condensation... though these are usually dry.

I have never had one of these tanks leak, even on the rebuilds, but I have noticed a lot of build up of juice in the drip tip cavity.
Everytime I refill, I do as Gran does, wipe out that hole. (Maybe I could have phrased that better)
 

Cheechako

Vaping Master
ECF Veteran
Verified Member
Feb 11, 2012
5,192
39,314
Arizona
Update: Loving the M! It has AWESUM flavor, and that's what i'm chasing. As a note the clouds ain't bad either with a 85% VG juice about half open air control. One further note! This thing burns through juice like a hemi engine eats gas, but I luv it! :vapor:

You're killing me! I'm so green with envy!
Tomorrow, tomorrow, it's mine tomorrow, my precious! :D
 

IMRs

Vaping Master
ECF Veteran
Verified Member
Sep 15, 2013
4,047
32,426
Penn's woods
I have never had one of these tanks leak, even on the rebuilds, but I have noticed a lot of build up of juice in the drip tip cavity.
Everytime I refill, I do as Gran does, wipe out that hole. (Maybe I could have phrased that better)

How long do you peoples use your coils until a change?
 

IMRs

Vaping Master
ECF Veteran
Verified Member
Sep 15, 2013
4,047
32,426
Penn's woods
Update: Loving the M! It has AWESUM flavor, and that's what i'm chasing. As a note the clouds ain't bad either with a 85% VG juice about half open air control. One further note! This thing burns through juice like a hemi engine eats gas, but I luv it! :vapor:
juice = flavor :)

1970_Plymouth_Hemi_Cuda_by_Qphacs.jpg
 
Status
Not open for further replies.

Users who are viewing this thread