Eleaf iPower Firmware and Logo Discussion

[Vaep]

One thing I found out is that if you leave your mod connected to your pc while you have the software open, sometimes my mod turns off and basically becomes unresponsive (bricked)....... I tried re updating the firmware and it turned on again and worked fine. SO yeah, if your iPower stops working, you might just need to re update.

Anyone have any custom logos they wanna share? I just made one using MSPAINT. I originally tried using Gimp Image Editor but it did not work. MSPAINT is the easiest way to make your own logo. Just edit the original logo :]

eleaf iPower 80w TC 5000mah -- Wotofo Serpent 0.6ohm 26g Kanthal @ 27.5w -- Logitech G Pro

 

[vilkslt]

Hi. i wanted to update firmware to 1.03. But the updater is not respoding then i connect mod to pc. And it doesnt find my mod. Windows 10. Why?

 

[KenD]

Hi. i wanted to update firmware to 1.03. But the updater is not respoding then i connect mod to pc. And it doesnt find my mod. Windows 10. Why?

Have you tried running the program in administrator mode (left click, "run as administrator"). I seem to remember that I had some problems running the program with the newest Windows 10 updates.

Sent from my M7_PLUS using Tapatalk

 

[vilkslt]

Yes i did this. But problem The same.

 

[jjcordone]

I had the same problem. Switch to the cable that came with the iPower, then with the firmware updating program open and the iPower turned on, try switching the cable to different USB ports on your machine. Mine suddenly started working on one of my USB ports. The firmware upgrade runs in seconds once you get windows 10 to recognize the device. Good luck!

 

[vilkslt]

i tryed other usb ports. nothing;/ but i will try to do the same like you

 

[Ellany]

i tryed other usb ports. nothing;/ but i will try to do the same like you

try resetting the device, helped for me