• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

elites usb pass thru

Status
Not open for further replies.

pfaber11

Ultra Member
ECF Veteran
Dec 16, 2009
1,389
901
england
just made myself an elites usb passthrough . not too difficult although the positive lead is very thin and if it breaks would be nearly impossible to replace. now produces a decent amount of vapour at 1 amp and 5 volts. i do have another one at 1.5 amps and 5 volts but it seems to scorch the juice a bit and almost too much vapour. any way way better than a standard elites and at least its better than tossing the elites. to be honest i do not see how anybody could quit smoking using one of these things. just not enough vapour. loads at 5 volts though.
 

pfaber11

Ultra Member
ECF Veteran
Dec 16, 2009
1,389
901
england
yes i would agree straight out of the box they are useless . just not enough vapour . i have made a couple of passthroughs before so knew what to do but if you have not then it could
be difficult and easy to screw it up. the wires inside are very thin and could break off so a steady hand and care are needed. still the end product is pretty good. the cartomizer which i turned into a dripping atomiser has been going for over three weeks now and is as good as new. i do use unfavoured juice though and never clean my atomisers. not necessary if you use unfavoured. just thought i would share this.
 

Veyf

Full Member
Verified Member
Nov 24, 2012
49
21
34
Stoke-on-Trent, UK
Nice update, really is vaping on a budget.

I can't help but think that £10.63 including shipping for a 1100mAh ego battery, usb charger and phoenix rebuildable atty clone is better value though.

Granted you will need some kanthal and wick but I think after purchasing those then you will more than break even before the supplies run out.

You can save 20p or so if you drop down to a 650mAh battery.

Source: Vaporbreak
 
Status
Not open for further replies.

Users who are viewing this thread