Empire Mods LR510 vs Cisco LR510 vs Aero Cisco LR510

Status
Not open for further replies.

rc10mike

Super Member
ECF Veteran
Verified Member
Mar 26, 2012
418
595
Jacksonville, FL

TennDave

Vaping Master
ECF Veteran
Verified Member
Dec 19, 2010
9,988
8,034
65
Knoxville, TN
I've only had the Aero- finally, after 3 weeks of fairly constant use it bit the dust with over 90ohm reading.
I had two- the first one died in less than a day....and I wasn't impressed with it.
The 2nd Aero on the other hand was really really good until it died. I too am one of those that won't buy the HH357 again.
 

wongster360

Super Member
ECF Veteran
Verified Member
Mar 11, 2011
879
1,965
Washington
I was less than impressed with the two HH.357's that I had. In the almost year and a half that I've been vaping, I've remained a carto kind of guy, mainly because of the low maintenance and ease of use. (Plus they aren't anywhere near as messy as atty's are, I'm a horrible dripper)

I have to admit, I bought 20 Joye510 2-2.5ohm atty's from the deal the MXBNW passed around. I'm on day 4 of the first one on my kicked 18490 and I find that it's really hard to put the mod down. I have the kick set at 10watts and it's vaping at 4.5volts and it's showing no signs tightening up at all. I'm becoming a fan of these really quick!
 

Decidion

Senior Member
ECF Veteran
Verified Member
Dec 2, 2011
212
252
Washington State
I bought a couple of the Empire Mods LR 510s and I used them for about a week before giving up. I wanted to use them longer, but what I found was that after about the third draw, they would get searing hot and after that produce little to no vapor until they cooled down. The other downside was that they spit into my mouth *a lot* and I was always vaping next to a garbage can to spit it back out. After the week was up, I went back to HH.357s.

On a side note, when the new HH.357s tightened up, I just drilled out the holes at the bottom with a 1/16" drill and they have worked very well since.
 
Status
Not open for further replies.

Users who are viewing this thread