Endura tank/coil

[Red Waller]

Hello, new vaper here. I currently have an Endura T22 starter kit (in addition to a mech tube mod a friend got me to get me into mods).

The thing is, I don't want the Endura to go to waste, but the coil, after around 2-3 weeks of use, is now giving me a burnt taste and is completely unusable in my book. I tried going around local stores (I'm from the Philippines, and here, we can't exactly just buy new coils for the device as they're not readily available; if they were, I also highly doubt that they'd be cheap) so:

I was wondering if it's possible to use a rebuildable atomizers with it, preferably an RTA/tank; or are there other clearomizers that I can use — clearos with possibly more common coils (also not sure about the availability of coils for other devices since most things I see on display here are really rebuildables, though I have seen some like the Protank III, Joyetech Cubis tank (honestly not sure what kind of tanks these are just yet, just naming the tanks I've seen that I don't think are rebuildable, when it comes to these things, my noob-ness becomes evident) and a couple of others that come in sets like this, Lite 40 is an example I could think of; not sure if the Kangertech Topbox is in the same category as the Endura, but those are more common and is in almost every store here).

If not, is my only other option really to buy a replacement coil/atty from Innokin (I've also used the spare)?

Thanks in advance, and apologies if this comes off as an ignorant question. I'm still not very familiar with the technicalities of vaping devices, as evidenced above. I would not have asked if I wasn't desperate, I just couldn't find anything about it on the Internet.

 

[Izan]

Hi and welcome

yes.

 

[Red Waller]

Hi and welcome

yes.

Thanks very much.

Yes I can use it with rebuildables or just other clearos? I once asked a seller here who seemed unsure of my unit, and he said the Endura (being a maximum 14W device) may not be able to handle RDAs/RTAs/their other tanks so IDK.

 

[Izan]

Your options are limited by the minimum resistance value of the unit. (1.2Ω)
ANY 510 threaded topper will attach to your battery and unless it is pulling more then 3.5Amps, it will fire.
If you have other tank/topper options available in the 1.2Ω-1.8Ω range, they should work flawlessly.

Do you have the option to order new T-coils from the same place you sourced the kit?

Cheers
I

 

[Red Waller]

I think I got it; if I get any tank with a prebuilt 1.2-1.8Ω coil, I'm good to go? And I'm still reading up on other stuff, but if I get a rebuildable, if I'm not misunderstanding this, I'd just have to make sure my build would always fit under the limitations (amps, watts, etc.), is that right?

Yes, I was finally able to contact my seller and they do have replacement coils (limited stocks but they've placed orders for more); unfortunately, their location is just less convenient compared to the others close by (most are very sub-ohm/rebuildables oriented, I've noticed, which is unfortunate because every time I step into those places I feel like even more of a noob) and I've seen available replacement coils in online resellers here for other clearos now as well, so that's a relief.