Enjoying RBA! Need mod recommendation!

[Anne99]

I went to a brick and mortar near me and it was great! They were very professional, knew there stuff, and the store was very clean. After asking some questions I decided to get the Agat2 and they even set it up for me. If you are in Richmond and have not been to voltage vaping I highly recommend it. I would like to get a mod to go with it that is smaller than my vamo 2. K100 maybe? What short mod would work well with the Aga t2?

thanks!

 

[ImThatGuy]

If you're going higher than 1.3 ohms then go with a variable voltage mod that is in 18350 mode. If the ohms is lower than 1.3 then go with a mechanical mod that is in 18350 mode. 18350 mode being that it uses an 18350 battery. Very small and compact. Downside to using 18350 batteries is that it doesn't have that much mah compared to the larger batteries so less vaping time.

There are some VV mods and mechanical mods that can do 18350 mode.

 

[degnr8]

Depending on how small you want to go, there are 14500 mods as well. Fasttech has what's essentially an ego body with replaceable batts for $12. As thatguy pointed out though, the smaller the battery teh lower the mah you'll be able to get.

 

[EmeraldLeo1982]

Lower mah isn't always bad. If he wants to go sub-ohm he'll need a high C rating battery which only comes in the lower mah's.

 

[Baditude]

I don't recommend sub ohm vaping (1.0 ohm or less) for beginners. Resistance that low requires IMR high drain batteries that have a high C rating/high amp capacity, which can only be found in the larger 18650 IMR batteries. Most recommended are the red AW IMR 18650 1600mAh battery or the MNKE IMR 1500mAh battery which have an amp capacity of 20. Use only the highest quality batteries in an RBA.

http://www.e-cigarette-forum.com/forum/entry.php?b=4454&bt=8879

http://www.e-cigarette-forum.com/fo...help-picking-best-battery-sub-ohm-vaping.html

 

[Anne99]

Thanks for your thoughts so far guys! Funny you should mention sub-ohm. Now I was vaping my new RBA and noticed that it will not work on my Vamo atm. It seems to be around 1 ohm. (This is still the one the the nice person in the store built for me). So as soon as I find where I put the small screw driver I will try to built it myself and shoot for something standard like 1.8 or 2.

I do like the form factor of the K100 but I also love VW. Still, its not like the K100 is that pricey!