Evic Menu question

[DHCrocks]

Hi,
this may sound strange but I can't figure out a couple of thing on my evic. I have version 1.3 and in configure there is screen and system. There are options for times what exactly does it adjust?

 

[NicoHolic]

Screen is how many seconds the display stays lit after a click and system is how long the PV sits unused before going to sleep.

 

[JonnyB88]

NicoHog is absolutely correct.
Also, if the pre-set times aren't doing it for you, you can set your own custom times in MVR.

 

[Gentle Jack Jones]

How do you get MVR?

 

[JonnyB88]

How do you get MVR?

Connect your eVic to your computer via USB. If it doesn't automatically ask you to download the MVR software, simply go here:
Joyetech download

 

[Gentle Jack Jones]

Thank you!

 

[DHCrocks]

thanks. for the system, I think that works fine, I set it at 60 min and when I woke up in the morning it was off and I had to 5 click to get it back on.

for screen it it had 10min, 30min....or something like that. I set it at the shortest and then took a hit. the display showed the draw time and then went blank in about 2 seconds. is it supposed to keep that display on? not sure what the screen option is doing.

 

[NicoHolic]

Click the fire button for 1/2 sec and see how long that display stays on.

 

[Gentle Jack Jones]

I'm getting the overhead flash button sometimes. Even when I'm not chain vaping. Is there a setting that may be wrong?
Are there average Volt and wattage setups that you can suggest?

 

[DHCrocks]

gentle jack, i'm assuming you mean the overtemp flash (looks like a thermometer) I was getting that too so I just set the alarm temp higher. I think the factory setting was really low that even when charging it would flash.